Street Service Pricing

Basic Suspension and Chassis

  • Remove and install front forks (sportbike)
  • Remove and install front forks (touring bike)
  • Fork seal replacement (std. forks) | (inverted or cartridge type)
  • Install fork springs (includes cutting of spacers)
  • R&R rear shock, check spring rate or change rear spring
  • Install and bleed braided brake lines front rear
  • Change brake pads per caliper
  • Clean calipers during pad change
  • Rebuild calipers + parts
  • Measure and adjust sag and compression and rebound settings
  • Install frame sliders no cut, (includes cutting holes if applicable)
  • Install clip-ons
  • Install Brembo (or aftermarket) master cylinder
  • Install steering damper
  • Install rearsets
  • Safety wire complete bike (clips included)
  • Install chain/sprockets
  • Install aftermarket body/fairing
  • Change/flush brake & clutch fluid

 

Fuel/Electronics

  • Install Bazzaz FI system or Dynojet Powercommander PCIII
  • Install quickshifter
  • Weld in exhaust bung for air-fuel module (O2 sensor)

 

Engine/Service

  • Oil/filter change (includes general check over)
  • Valve adjustment
  • Coolant change + supplies

 

Tire/Wheel

  • Front or rear sportbike (on bike) (includes balancing)
  • Front or rear sportbike (wheel only) (includes balancing)
  • Balance only
  • Wheel bearing R&R per wheel
  • Bead blast rotors each